Fit check

Hobie Mirage Pro Angler 14
with the
Wheeleez Kayak Cart Beach

Recommended Inferred— evidence level: No direct fit report exists. Our published rules engine compared measured cart geometry and capacity against measured kayak geometry and loaded weight. Geometry is not the same as a real-world fit.

This pairing works. The load margin is sensible and nothing about the hull or the cart geometry fights you.

What to watch

  • Positioning matters on this boat: MirageDrive well is a large opening mid-hull — do not position a cart under it.

    • Kick-up rudder at the stern. Positioning a cart too far aft can load the rudder assembly.
    • Retractable transducer shield underneath the hull.

What works

  • Load margin is moderate at 82% of the rated capacity.
  • 30 cm polyurethane balloon wheels handles hardpack well.

Load margin as you actually load it

Against a planning capacity of 80 kg (176 lb) . Starting point is the rigged weight of 65.5 kg, not the 54.7 kg hull figure.

Boat only

65.5 kg / 80 kg

As it comes off the roof bars, nothing aboard.

82% — Moderate. 70–85% of rated capacity. Fine on firm ground. Watch for frame flex over kerbs and roots.

Light day kit

73.5 kg / 80 kg

Paddle, PFD, dry bag, water, small anchor. (+8 kg)

92% — Near maximum. 85–100% of rated capacity. No margin for shock loads. Avoid drops, kerbs and stairs.

Loaded fishing rig

85.5 kg / 80 kg

Crate, battery, fish finder, rods, tackle, catch. (+20 kg)

107% — Exceeds rating. Over the manufacturer rating. Do not use. Frame, axle or wheel failure under load is a real injury risk.

Gear figures are our standard scenario weights, not measurements of your kit. Swap in your own on the weight calculator.

Hull and cart geometry

The boat

Hull shape
Pontoon / catamaran (twin sponson)
Beam
96.5 cm (38 in)
Cart policy
platform only

The cart

Pad type
Padded cross members
Pad geometry
Not published
Width range
Not published
Cart type
balloon-wheel strap-on cart

Where the cart cannot sit on this hull

  • MirageDrive well is a large opening mid-hull — do not position a cart under it.
  • Kick-up rudder at the stern. Positioning a cart too far aft can load the rudder assembly.
  • Retractable transducer shield underneath the hull.

How to position a cart correctly

Across the ground you cross

Verdicts recalculated for each surface at the light-day-kit load. Terrain scores are our declared judgement scale from wheel geometry and construction — not instrumented pull-force testing.

Fit verdict and rolling score by terrain for this kayak and cart
Surface Rolling Best wheel Verdict
Sealed car park / boat ramp Workable
Hard-packed dirt track Workable
Grass / turf Workable
Gravel or shingle Workable
Wet / firm sand Workable
Deep dry soft sand Workable
Mud / tidal flat Workable
Steps or a steep bank Caution

Documented failure modes for this cart

Reported by owners, not by us. These are not specific to your kayak, but they are what goes wrong.

  • Modest payload for rigged fishing kayaks

    high Mfr confirmed— evidence level: The figure or fit statement is published by the manufacturer of the kayak or the cart, in their own documentation, spec sheet or support channel.

    80 kg is comfortably enough for a touring or recreational kayak, but a rigged pedal fishing kayak will exceed it on its own. Check your real carry weight first.

  • Balloon wheels are less good on hard ground

    low Inferred— evidence level: No direct fit report exists. Our published rules engine compared measured cart geometry and capacity against measured kayak geometry and loaded weight. Geometry is not the same as a real-world fit.

    They work everywhere, but on tarmac a rigid wheel rolls with less effort and less squirm.

Other carts for this kayak

Sources last checked:
Sources (4)